Weekly Roundup 2/11/12

February 11, 2012 By Leave a Comment


In case you have been on vacation, here is the best that we have had on our blog in the past week:

In first place is a post about [the University of Pennsylvania’s] quadcopter team. This time they have a group of twenty quadcopters flying in formation.

In second place is a post about a nice project by [Joel] where he converted an overhead projector into a TV projector by projecting through a LCD TV. He went all-out on this one by using a CNC machine to cut out a special holder for the LCD and the fans necessary to cool it.

Next up we have a post about a project where a 55 gallon plastic barrel is turned into a wind turbine. We’re not sure about how much power this would produce but it would probably be fun to play around with.

Following that is a follow up post about Printrbot, an inexpensive 3D printer which we previously posted about. It was a successful Kickstarter project a couple of months ago and now the design files have been released into the wild. Check it out!

Finally we finish off with a post about how to build a solid-state Tesla coil. It’s presented in an Instructable with 12 easy steps so that you too can feed your high-voltage addiction.

Filed Under: news, Weekly roundup Tagged With:

Robotic Etch-a-Sketch Draws Grayscale Images

February 6, 2012 By Leave a Comment

[Patrick] decided to make a computer controlled etch-a-sketch. While the idea is not that new, there is always a different way to accomplish a goal. An Arduino is used to control a pair of stepper motors which were sourced for pretty cheap, and even came with their own driver. Next a stand was mocked up using foam board, which helps determine where all the parts should live.

Next was a way to attach the steppers to the knobs, gears would be used and a collet meant for model airplanes was sourced to make the mechanical connection between gear and shaft. With everything set in place via foam board and paper printouts, it is off to get some thin plywood. The plywood is sent though a laser cutter creating most of the stand and gears. Now its all software, a program was whipped up for OSX which converts low res pictures into squiggly lines perfect for the etch-a-sketch to draw on its screen.

The results are quite impressive, join us after the break for a quick video.

[Read more…]

Filed Under: arduino hacks, news, toy hacks Tagged With:

Kinect for Windows released

February 2, 2012 By Leave a Comment

Even though we’ve seen dozens of Kinect hacks over the years, there are a few problems with the Kinect hardware itself. The range of the Kinect sensor starts at three feet, a fact not conducive to 3D scanner builds. Also, it’s not possible to connect more than one Kinect to a single computer – something that would lead to builds we can barely imagine right now.

Fear not, because Microsoft just released the Kinect for Windows. Basically, it’s designed expressly for hacking. The Kinect for Windows can reliably ‘see’ objects 40 cm (16 in) away, and supports up to four Kinects connected to the same computer.

Microsoft set the price of Kinect for Windows at $250. This is a deal breaker for us – a new Kinect for XBox sells for around half that. If you’re able to convince Microsoft you’re a student, the price of the Kinect for Windows comes down to $150. That’s not too shabby if you compare the price to that of a new XBox Kinect.

We expect most of the builders out there have already picked up a Kinect or two from their local Craigslist or Gamestop. If you haven’t (and have the all-important educational discount), this might be the one to buy.

Filed Under: Kinect hacks, news Tagged With:
Newer Posts »